Forum Replies Created
-
Finished grinding welds on the bulkhead repair yesterday. Moved onto grinding welds on the long side.
Trimmed and fit the driver side rear wheel well repair section. 
Cut out the driver side battery tray and mudflap earlier today.
Cut part of the driver side D Pillar out as well. Forgot to take a picture, so I’ll snap one and throw it up on Friday. Dissected a chunk of the D pillar off the passenger side. 
Fabricated a lower bulkhead patch for the driver’s side this morning.
Dad finished welding in the Lower B Pillar and bulkhead patch on the passenger side.
Been fitting and weld prepped the driver’s side cargo floor structure. Started with the rocker, then moved to the rear top hat and outrigger, and ended with the front top hat and outrigger.
Today felt like playing with Legos. Putting pieces together to create a finished product. In this case, the structure of a cargo floor!Cut and dissected the majority of the floor out today.
Dad dissected a bit off the front cargo floor, around the lower windshield, and cut around the passenger seat buckle mount.
Nice to work out in the ☀️ today! A little more dissecting on Monday then should be back to blasting 😎
Scraped the trans and got it disassembled. Much cleaner than what it was. The bottom was a mess.
Dad scraped the trans cradle while I was on the transmission. He’s currently getting the bus cradle welded on.
Dad and I got the transmission and front beam out this morning.
Im about to start scraping the trans.
Hard to see, but pretty sure Franz and I were giving you the bird 🤣
Driver D pillar ended up being about the same as the passenger. Had to cut all that rust out.
Also cut off the bottom of the corner. Battery tray is still fine.
Been dissecting bits off around the bus today. Primarily focusing on the rear of the bus though. Cut off the pass side mudflap and bottom corner since they were rusty.
Dissected all the little bits off the pass side battery tray as well.Now starting to dissect the driver side.
Worked on getting the belly pans fit today.
Ended up punching holes all along the belly pans instead of drilling, so my arms are very tired 😅JJ got those welded in.
Finished my day out by sanding the roof of the bus and finding the dents in the roof. Just started pulling those out before I ended my day.Went to Cup Practice/Qualifying and the Xfinity series race yesterday. The new Cup cars sound badass in person! They look pretty cool too 😎
Xfinity race
