Home › Forums › KCW Current Projects › PatK’s Class 5/1600
-
AuthorPosts
-
Really like the progress Pat. Got the racing schedule planned for next season ?
Planing to race the BOR series in Utah. First race should be early May if the schedule is the same as last years.
Fit and burned in a few panel tabs yesterday.
Couple more panels templated also.
We will build it if it comes.
This thing is so badass! I love all the triangulation construction. Going to be tougher than a two dollar steak!! GO RACING!!!!
Looking awesome!!! 🔥🔥🔥 can’t wait to cheer you on and help however I can in May!!! 👏🏻🤩
Pat getting ready for his Dickies photo shoot.
Sparks just look cool!
Gettin it done this weekend!!!
Knockin shit out!!!!!😎. One project at a time👍🏻
Made good progress over the weekend on this.
Templated, fabed, and welded in the front bash guard for the rear skid plate. 3/16” steel plate to “absorb” the initial impact.
Rear skid plate’s templated.
Front beam adjusted skid also.
Kill switch mounted between the seats within easy reach of driver & co-driver
We will build it if it comes.
Can’t wait till the first test drive 👍🏻👍🏻👍🏻
Knockin shit out!!!!!😎. One project at a time👍🏻
Check it out with the front end on👍👍👍❤️👍👍👍👍👍👍👍❤️👍👍❤️
Knockin shit out!!!!!😎. One project at a time👍🏻
Beast!
Knockin shit out!!!!!😎. One project at a time👍🏻
Put some time in on this one yesterday.
Fit and burned in a cover panel where the pass grab handle shaft pokes through the dash bottom side.
Trimmed up some 3/16” alum plate for the pushrod tube skids.
Same for the bottom adjuster skid on the beam. Top plate is a lot thinner .040 alum.
More panel work this morning.
We will build it if it comes.
Gettin after it!
Knockin shit out!!!!!😎. One project at a time👍🏻
This is going to be a fun kickass ride. Would love to ride in this.
Tim
-
AuthorPosts
- You must be logged in to reply to this topic.