-
AuthorPosts
-
Starting up a thread for my Only project at KCW! 😆 Wanna dial in a few of my drivers then get back onto this Rig!! 😀 😀 😀
Uugh,,, there’s some missing information for sure but I’m just re-starting a thread!!!!
Very Kool car…
From Zacks Gallery…. Type 1, Rusty folder…
Proud and Stubborn 👍🏻
Proud and Stubborn 👍🏻
Oh Damn!!! 😮 😮 😀 We should have scrapped this Rig!!!! 😆 😆
I eyeball this car every time I walk into the back. Love it
Need input here Folks!!!! 😀 I need to repair/replace the missing C channel on my front seat tops. Looks like from the welds the C was facing to the back, not down like later model‘s Does anybody have any idea what diameter these channels were?? Should I use a straight tube or was the tube slightly bent like the seat backs? Think cutting a slot in a tube is easier than bending sheet metal???
cut them off some later seat backs.
Proud and Stubborn 👍🏻
Yo Rusty. I was digging for parts earlier today. I found a strait back 53-55 front seat back that has the piece you need barely attached. I think its probably the same as your 52.
Hey if you have any more 53-55 front seats laying around I know a guy who needs a pair for a zwitter 😆 😆 -where’s the praying emoticon-
Great news Franz!!! 😀 😀 Sooooo, I also have the correct rear seat top for the Split, pretty nice shape and I’m all excited about the original tag I found on the frame 😀 Would you guys keep it as it is and re cover, or sandblast and powder coat??
Tag translates to “behind-leaning” 😀
You don’t have to powder coat everything just because you work at a powder coating shop. 😉 Its only OG once.
Jeff, I’ll send this backrest with Rusty. Hopefully its something you can use.
I would give my left nut to see you finish this rig and take it home… 😎
Proud and Stubborn 👍🏻
-
AuthorPosts
- You must be logged in to reply to this topic.