-
Painting went awesome yesterday. I finished the 4th coat of clear at 11pm.
I feel worn out this morning. But the results are worth it.
Got everything dialed in on Dans diesel gas heater install this afternoon. Â Puts out tons of heat!!!
Had to bend a few brackets for mounting, drill a couple of holes in the floor for intake and exhaust, run intake exhaust and duct piping, mount the fuel tank, and run fuel and electric lines.
Also installed a fuse panel under the bed that is easily accessible and handles all of the duties for the secondary battery system.
Made a couple of protective shields for the wiring/fuel line track and fuel pump so Dan can still use his storage under there.Â
splash shield for the intake.
Took it for a test drive. Went good for a bit but shifting felt a little strange. Called our builder after we all test drove it. They think it’s the aftermarket nose cone that was produced incorrectly that they’re just discovering they got a batch of and just recently diagnosed the issue after starting to hear from customers all having the same issue.  Pulling everything back out now to remedy the issue.
Sorry Dan.Â
We will build it if it comes.
Not sure what brand the heater is Johnny, no manufacture name on it, Dan got it off of eBay. Fuel tank is about 1.5 gal.
Got everything back together. Shift smooth as butter and runs great. Nose cone was the issue.
We will build it if it comes.
- You must be logged in to reply to this topic.