Home › Forums › KCW Completed Projects › Panama Red
-
AuthorPosts
-
Riley is on the dissecting right now… We should be able to start putting some new metal in next week I hope!!!
Proud and Stubborn 👍🏻
Did a TON more dissecting on the floor yesterday. Where I started:
Where I was at by lunch:
Where I finished my day at:
Spent another day dissecting. I finished up the floor.
Then started dissecting other spots on the passenger side of the bus. Got most of the way done dissecting that side overall!Nice work Riley!
stoked to check this one out tomorrow !
getting there on disection, we will be pre occupied with getting ready to go to Idaho for the next few days.. ON like Vomit when we get back!
Proud and Stubborn 👍🏻
With Pat training Riley it’s like Kindall & Sons Metal Works in the Dirty Shop 😎
Kickin ass!!!
Fun Size👌🏻
Riley’s on it!
Riley’s on it!
Spent another day dissecting. Started my morning by cutting a rusty spot out towards the back.
Then followed that up by cutting out a strip of floor that was right next to it.
After that I dissected a strip of metal that was below the firewall behind where the seats would be.
Finished out my day by getting started on dissecting some strips on the passenger side of the cab!We’re back at it this morning.
Riley is just about done dissecting the last of the front floor bits.
I’ve knocked out a patch on the front of the pass rear fender well.
Fit the inner rocker.
Working on top hat sections.
We will build it if it comes.
Spent most of my day working on dissecting bits off in the cab. Took off a strip that ran along the inside.
Then dealt with two large strips that were sitting on the middle beam and the left beam.
After that I moved onto the passenger side of the bus and started dissecting spots along there.Good day!!! We kicked ass!!!
Thanks for staying focused on the tedious dissection Riley! Your knocking it out!
Burned in all of the passenger main structure. Also fit and burned in the middle and front pass outriggers and jack points.
Made a patch for the pass lower bulkhead/fender well section.
We will build it if it comes.
Half way through my day. So far, I’ve cut out a rusty spot around the bulkhead and top hat on the passenger side of the bus.
Next up is to cut out the rear center section. -
AuthorPosts
- You must be logged in to reply to this topic.