Forum Replies Created
- volksaddictParticipantNovember 5, 2018 at 6:31 amPost count: 620volksaddictParticipantNovember 4, 2018 at 6:21 amPost count: 620volksaddictParticipantNovember 4, 2018 at 6:18 amPost count: 620
Putting my undercarriage back together, yea. Always nice when it’s not scattered all over the shop! replaced my front torsion bar, that’s why it had coilovers on the front. Only had a later style, non welded leaf set to put in, Bently says not to replace welded torsions with non welded, guess I’ll find out if they wander out of the hole…volksaddictParticipantNovember 3, 2018 at 7:30 amPost count: 620volksaddictParticipantNovember 1, 2018 at 7:11 amPost count: 620volksaddictParticipantNovember 1, 2018 at 7:07 amPost count: 620volksaddictParticipantNovember 1, 2018 at 7:02 amPost count: 620volksaddictParticipantOctober 30, 2018 at 8:43 amPost count: 620
I could sure use the 4 pieces, 2 slider 2 fixed! I’d be happy with anything og that you can see thru, Thanks!! That’s awesome John. I owe you for sure!
I saw the eis ones, would go that way if I had to, stock with scratches is better 🙂
I am surprised you are running a split case trans in this
A small nut would be nice but I have the split case, it’s orig to the bus and works fine. They seem to do well with a single port 1600 or smaller motor, and there are no freeways in my ‘hood, don’t need to get much over 60mph. Not sure what I’ll do for a motor yet, I have most of the stuff for a 40hp sitting here…
I like the old 40 hp motors.volksaddictParticipantOctober 30, 2018 at 7:37 amPost count: 620
I got my door hoops ready for reassembly and then realized I have no slider or fixed panes 🙁 The glass that was on this bus – it was hazed real bad, etched. I don’t know wtf happened to it… I picture the bus body sitting in some yard next to a refinery or chemical plant. Tried to clean it, you can feel the hazing etched into the surface. I got rid of 1 side on the green westy (sorry new owner!) thought I had a good set stashed but I guess not.
Where do you guys get new? Orig style with the hole for the latch. Does laminated even fit in the felt seals?volksaddictParticipantOctober 30, 2018 at 6:31 amPost count: 620volksaddictParticipantOctober 28, 2018 at 6:40 amPost count: 620volksaddictParticipantOctober 28, 2018 at 6:37 amPost count: 620volksaddictParticipantOctober 27, 2018 at 7:51 amPost count: 620volksaddictParticipantOctober 23, 2018 at 7:00 amPost count: 620volksaddictParticipantOctober 20, 2018 at 8:23 pmPost count: 620volksaddictParticipantOctober 19, 2018 at 7:59 amPost count: 620volksaddictParticipantOctober 18, 2018 at 6:33 amPost count: 620volksaddictParticipantOctober 15, 2018 at 6:08 amPost count: 620volksaddictParticipantOctober 13, 2018 at 7:17 amPost count: 620