Forum Replies Created
-
AuthorPosts
-
in reply to: Mikes Dual Cab #37414
Dang, Dot3
I would crank it down tighter to seat it……maybe you already tried that.
in reply to: Toms rhd Oval Vert #37412Got some custom fram oil filter decals, and you know I’m going to paint the housing some good color. 🤪
in reply to: Juan’s 59 Lowlight #37411Brakes fully assembled, adjusted and bleed. Heater control and new cable installed. Pedals finished and adjusted, new Bowden tubes, new throw out bearing and super clips.
in reply to: Juan’s 59 Lowlight #37410Yeah it is.
Fixed, but I damaged the copper plating with heat. The end is just polished steel now.
in reply to: Juan’s 59 Lowlight #37405Running the engine this morning, I found a couple problems. The paper gasket under the generator was leaking or off center. I had to lift the fan shroud and glue it in place.
Then I noticed a fuel leak from one of the banjo solder joints. I’m going to try silver soldering it. We may have to make a new line if it doesn’t take.
in reply to: Juan’s 59 Lowlight #37398I like them all. 36hp are a beautiful engine.
I spent the rest of the day getting the chassis ready for body union.
in reply to: Juan’s 59 Lowlight #37392Runs great. No leaks. I drained the break-in oil and will adjust the valves when it is cooled.
in reply to: Toms rhd Oval Vert #37371Actually going to work on the engine this morning!
How is your project convertible Creig?
in reply to: Tabeguache Trailblazers #37370JJ is too fast. We lost him this morning. Gnarly whoop hill climb for sunrise.
in reply to: KCW randomness #37363Nice horn. 👍
in reply to: Je$$e’s (aka Tintop) Projects #37362Push rods in and valve covers on. I had to re-shim a couple of the rockers. New ngk spark plugs too ⚡️
Waiting on tin and exhaust now.
in reply to: Je$$e’s (aka Tintop) Projects #37350Speedometer and push rods came in.
in reply to: Tabeguache Trailblazers #37330See you there
in reply to: Doghouse cooler seals #37302The pink and white ones on the end are Empi high quality silicone and slightly thinner at 3.6mm
in reply to: Doghouse cooler seals #37299I’ve had a problem with doghouse oil cooler adapter machine work. One of the 6m studs being just barely drilled into the oil galley, and weeping around the threads.
-
AuthorPosts