- FunkuponatimeParticipantMay 18, 2020 at 9:40 pmPost count: 2
Thanks, i reached out to them. These guys are in Thailand, so not so far away.Pat KKeymasterMay 20, 2020 at 10:56 amPost count: 1265
More parts rolled in for this one. New torsion bushing in, spring plate angle set, all bolted down and ready for brake assy.
Cleaned out all of the cable tubes. Round one!
Gets a little better each time.
After about ten rounds it comes out as clean as it goes in.
Both heater cable tubes had broken off cables stuck in them. That sucked!
Early ovals had a shorter straight shift rod. We didn’t have one but we had the parts to make one.
Installed the modified rod along with a shifter. Everything works great! Need to pull everything back apart for finish welding.
We will build it if it comes.Lone StarParticipantMay 20, 2020 at 1:33 pmPost count: 147
Good to see this one moving along. Great thinking on fabricating the shifter rod. I had been hunting for one, but no luck.BBWBParticipantMay 21, 2020 at 9:16 amPost count: 795
I love making chips! Nice job Pat.
I'm at the age where "fuck off", "fuck you", and "fuck it" answer most questions.Pat KKeymasterMay 22, 2020 at 10:06 amPost count: 1265
Every time I use the mill or lathe I think about all the hours men and women spent standing at these things turning knobs to make parts for years and years and years before the CNC bullshit came around killed a skilled trade.
Knocked 3/4“ off each drum snout because we’re running short axles.
Rear brakes assembled and drums on.
Also fit and tacked down the pan gasket.
We will build it if it comes.
- You must be logged in to reply to this topic.