Home › Forums › KCW Completed Projects › Early Westy Sub Hatch Interior install.. PGSG 58
-
AuthorPosts
-
Pulled two Westy wooden flip seat backs from KBs stash that still had hinges attached.
Scraped and sanded them down and made a couple of veneer repairs. I’ll start clearing them tomorrow.
Sanded and laid down final coat on this round of cabinets.
Installed passenger toe kick yesterday and got started on the door panel..
Finished the door panel this morning. WW is closed so I’ll have to paint handle escutcheon black.
We will build it if it comes.
WOLFSBURG WEST IS CLOSED!!!!!! That blew my mind this morning…. 😎 😎 Thats a whole nother variable for my shop and work… not being able to get the parts we need….
Pats doing an awesome job!!! Thanks Pat K!
Been a wild ride, but it got me here 😎
I think Pat may be ready for some panel installation next week!!! Floor looks like a dance hall floor!!!!!!!
Been a wild ride, but it got me here 😎
I think Pat may be ready for some panel installation next week!!! Floor looks like a dance hall floor!!!!!!!
Almost!!
I did get the first coat of urethane on the front side of the seat backs on Fri night and second coat of stain on the floor panel.
Also fit and installed driver side toe kick and got started on the door panel as well.
Sanded seat backs and laid down second coat on the front sides first thing last night.
Finish driver door panel install.
Knocked out a bit of cabinet assembly to finish off my night shift.
We will build it if it comes.
Going to be better than new. Of course that is normal at KCW.
Dance Hall floor!!!! Going to be “slippery when wet”….. 😎 Like most the lucky ladies that sleep in this bus…. 😎 😎
Been a wild ride, but it got me here 😎
Awesome Pat! A nice new shiny interior is great, it just opens up and lightens up the bus visually. Well done!
I bet next week we see some big strides on this one!!!!! 😎 Some Installation!!!!
Been a wild ride, but it got me here 😎
Sanded and laid down the final coat on the front side of these seat back first thing last night.
Picked up some fine rib rubber mat for the rear parcel tray yesterday. Cut to fit. Turned out great!
Cleaned rear corner panel trim and just finished installing corner panels.
We will build it if it comes.
so nice Pat. I hope to see this bus
Floor panel fit tits!
Long side panel next.
Bulkhead panel fit and screwed down,
Pass side rear quarter and cargo door panels in place.
We will build it if it comes.
-
AuthorPosts
- You must be logged in to reply to this topic.