-
Painted all areas that we wanted Hanover sealer gray this morning. Sanding drivers dog leg, last spot, before we can mask for the sealing wax red paint session.
Batt tray areas.
Passenger front areas.
Driver front areas.
Cargo rocker.
We will build it if it comes.
Middle and outer rockers fit and welded.
Outer and middle ready to burn in tomorrow. Silver White bumpers coming soon!!!I’ve never seen a middle rocker before. Is this specific to single/double cabs?
Don’t think my SC had one. Mind you there wasn’t much rocker left when I got it.
^^^ get back to u on that Jerm. In the middle of something.
In the booth. Masked off. Ready for paint !!!
We will build it if it comes.
JJ painted pedals and prop rods this morning he’s also been buffing the nose.
I pulled parts from storage and started on assembly. Buffed on the drives side dash. Steering column back in and connected, high beam switch, horn, and pedal levers done.
We will build it if it comes.
The OG manuals are always handy 😎 Pats been working on more Assembly today! + getting those beauty shots of his work of course 👌🏻I’ve been focusing on finishing pedal assemblies this morning.
All pedals, cables, and NASA linkages done down under.
New shift boot and throttle linkage seal. Need to order an ebrake boot and a few other rubber bits for this area before its done.
Ready to install the motor.
Check out this fancy vintage oil cooler!
We will build it if it comes.
I finished motor install yesterday. Started right up.
Had to shorted the batt hold down strap.
Body worked, primed and painted the rear apron repair this morning.
Engine bay prop rod rest was broken off. Bent up, welded, and painted a new one.
Treasure chest rest was still there, just had to bolt on the prop rod.
We will build it if it comes.
More lovin going on
- You must be logged in to reply to this topic.