Home › Forums › KCW Completed Projects › Bob’s 65′ camper
Looks great so far, I appreciate the hard work. Thank you, Bob
That shrinking disc is a little bit intimidating but boy does it pay off if you have the guts to use it! Nice work Pat!!!!!!
Dirty Pat is knocking this shit out, one dent, ding and shitty spot at a time!!!!!! 😎
Been a wild ride, but it got me here 😎
Talked with Painter’s Grinding about the engine and transaxle build yesterday. 3.88 and 1914cc baby tractor combo is on order.
Kicking ass pat? Like u never left!
Bob’s old engine was like .060. over on the mains and .080 on the trust…. We decided on a fresh case and new heads… 😎 Bob’s gonna love that 3.88 tranny combo!!!!!!
Great work, going to be another seriously useable bus.
That combo sounds great. What’s the specs on a 1914 baby tractor?
8:1 69mm x 94mm big valve heads, single springs soild shaft rockers w/ ball feet engle 110 cam dual 40 Weber IDF A1 sidewinder Full engine tin w/heat.
Sounds like a great cruiser setup!
Ok Cool. What’s the low end torque like with that setup? I like single port motors – best one I ever had was a SP 2110.
Back on this rig today. Finished up pass corner and batt. tray last Tues.
Tore into drivers that evening.
Lots of pushing/pulling and hammer/dolly work.
By end of day Wednesday had it looking pretty good.
Bit more of the same today. Just need to burn the inner section back in.
We will build it if it comes.
God I love the portapower
Damn nice job on that corner! ?
Tim
Nice work pat. Killin it??♂️